
Product
TP6306
UNB collector for RS485 meters and sensors, 470–510 MHz, up to 32 RS485 slaves, 220 V AC, 35 mm DIN rail.
- Frequency
- 470–510 MHz
- TX power
- Up to +20 dBm
- Sensitivity
- -111 dBm
- Package
- 101 × 40 × 55.5 mm
Technical specifications
Radio
| Operating frequency | 470–510 MHz |
|---|---|
| Transmit power | Up to +20 dBm, configurable |
| Receiver sensitivity | -111 dBm (downlink 19200 bps, uplink 2400 bps) |
Hardware
| Downlink bus | RS485, up to 32 slaves (6 on the -SE / -SE-A variants) |
|---|---|
| Interfaces | 220 V AC power input; RS485; Type-C (Bluetooth and debug); UNB antenna SMA female |
| Supply voltage | 220 V AC |
| Power consumption | <2 W |
| Dimensions | 101 × 40 × 55.5 mm |
| Mounting | 35 mm DIN rail |
| Protection class | IP51 |
Environmental
| Operating temperature | -25 °C to +75 °C |
|---|---|
| Operating humidity | 10–90% RH, non-condensing |
Variants
| TP6306-WL | Cold water meter collector, RS485 to M-Bus, 32 slaves, CJ/T 188 |
|---|---|
| TP6306-WH | Water control unit collector, RS485 bus, 32 slaves, private protocol |
| TP6306-EM | Electricity meter collector, RS485 bus, 32 slaves, DL/T 645 |
| TP6306-SE | Sensor terminal collector, RS485 bus, 6 slaves, Modbus RTU |
| TP6306-SE-A | Project-specific version of -SE (Science City smart IoT programme) |
Overview
The TP6306 is a collector rather than a radio link: it polls RS485 meters and sensors on the wired side and reports them over TPUNB at 470–510 MHz. A single collector handles up to 32 RS485 slaves on the -WL, -WH and -EM variants, or 6 slaves on the -SE variants, and supports both passive polling (commands pushed down from the platform) and periodic polling on a configured interval.
The four production variants differ in the meter protocol they speak: -WL for cold water meters over RS485 to M-Bus using CJ/T 188, -WH for water control units on a private protocol, -EM for electricity meters on DL/T 645, and -SE for Modbus RTU sensor terminals. All of them run from 220 V AC, draw under 2 W and mount on a 35 mm DIN rail in a 101 × 40 × 55.5 mm housing.
Radio output is below +20 dBm and configurable; sensitivity is -111 dBm with the downlink at 19200 bps and the uplink at 2400 bps. The unit is IP51 and rated -25 °C to +75 °C at 10–90% RH, so it lives in a cabinet or a metering room. Two status LEDs report UNB and RS485 link state and network joining, which makes commissioning a meter room a matter of watching two lights.
