Product

TP5608-FD14L20

Sub-1 GHz image and data link, IEEE 802.11ah, 1–8 MHz channels, 32.5 Mbps, Ethernet plus serial, 96.3 × 41 × 15 mm.

Frequency
Sub-1 GHz, 900 MHz antenna
Sensitivity
-105 dBm
Package
96.3 × 41 × 15 mm

Request datasheet & pricing →

Technical specifications

Radio

TP5608-FD14L20 Radio specifications
Operating frequencySub-1 GHz, 900 MHz antenna
StandardIEEE 802.11ah
Channel width1 / 2 / 4 / 8 MHz
Air-interface data rate32.5 Mbps (8 MHz, MCS7)
Receiver sensitivity-105 dBm (1 MHz PPDU, MCS10)
Operating modesAP and STA (relay, roaming and multicast supported)

Hardware

TP5608-FD14L20 Hardware specifications
InterfacesGH1.25-4P serial (TXD, RXD, 5 V, GND); GH1.25-4P Ethernet; GH1.25-2P power; SMA female antenna
Supply voltageDC 5 V / 12 V
Current consumption50 mA at 12 V
Dimensions96.3 × 41 × 15 mm

Environmental

TP5608-FD14L20 Environmental specifications
Operating temperature-20 °C to +70 °C
Storage temperature-20 °C to +70 °C

Overview

The TP5608-FD14L20 is a video and data link built on IEEE 802.11ah in the sub-1 GHz band, using a 900 MHz antenna. It offers channel widths of 1, 2, 4 or 8 MHz, an air rate up to 32.5 Mbps at 8 MHz MCS7, and -105 dBm sensitivity at the most robust 1 MHz MCS10 setting — enough to carry compressed camera streams where 2.4 or 5 GHz Wi-Fi will not reach.

One device carries two paths: a serial channel (transparent data and configuration) and an Ethernet channel for video. On the TP5608 both are GH1.25 connectors and power comes in on a GH1.25-2P at 12 V; current draw is 50 mA at 12 V. Units ship as a pair, one in AP mode and one in STA, with a pairing button on the housing.

Relay mode extends the link around an obstruction, STA units roam between APs, and multicast is supported for sending one stream to several receivers. At 96.3 × 41 × 15 mm and rated -20 °C to +70 °C it mounts on a drone, a robot or a camera pole; for 12 V-only sites use the 12 V input, and for USB-powered setups the 5 V rail is available on the serial connector.