Product

TPF25C-01-U1

Wi-Fi 802.11 b/g/n serial module on the Dialog DA16200: 15 × 15 mm, 20 dBm output, 0.2 µA sleep current, and TCP, UDP, MQTT and HTTP stacks on board.

TX power
Up to 20 dBm
Sensitivity
−97.5 dBm at 1 Mbps DSSS
Package
SMD, 1.27 mm stamp holes

Request datasheet & pricing →

Technical specifications

Product

TPF25C-01-U1 Product specifications
TypeWi-Fi 802.11 b/g/n module
Form factor15 × 15 mm SMD

Radio

TPF25C-01-U1 Radio specifications
ProtocolIEEE 802.11 b/g/n
ChipsetDialog DA16200
Frequency2.4 GHz band, 20 MHz channels
Transmit powerUp to 20 dBm, software adjustable
Receiver sensitivity−97.5 dBm at 1 Mbps DSSS
AntennaU.FL connector or stamp-hole pad

Network

TPF25C-01-U1 Network specifications
Wi-Fi modesStation and soft-AP
SecurityOPEN, WEP, WPA, WPA2
On-board stacksTCP, UDP, MQTT, HTTP
Typical range100 m measured; 115 m with a PCB antenna against a consumer router

Power

TPF25C-01-U1 Power specifications
Transmit current280 mA typical at 20 dBm, 1 Mbps DSSS
Receive current29 mA in low current mode
Sleep current0.2 µA (sleep 1), 1.8 µA (sleep 2), 3.5 µA (sleep 3)

Interfaces

TPF25C-01-U1 Interfaces specifications
SerialUART at 115200 bps
Flash32-bit on-board flash
DebugJTAG (TMS / TCLK)

Mechanical

TPF25C-01-U1 Mechanical specifications
Dimensions15 × 15 × 2.3 mm including shield
PackageSMD, 1.27 mm stamp holes

Environment

TPF25C-01-U1 Environment specifications
Supply voltage2.1–3.6 V, 3.3 V typical; 3.9 V absolute maximum
Operating temperature−40 to 85 °C
Storage temperature−40 to 125 °C

Overview

TPF25C-01-U1 is a Wi-Fi module rather than a Bluetooth one: it is built on the Dialog DA16200 and speaks 802.11 b/g/n in the 2.4 GHz band. The BLE part in this family is TPF25E-01-U1; the two are documented in the same style and configured over a serial port, but they are different radios and different chipsets.

The design target is the device that is online but mostly idle: 0.2 µA in the deepest sleep, 29 mA receiving, 280 mA transmitting at 20 dBm. TCP, UDP, MQTT and HTTP run on the module itself, so the host MCU only exchanges payload over a 115200 bps UART and needs no network stack of its own.

It supports station and soft-AP modes with OPEN/WEP/WPA/WPA2 security, carries 32-bit onboard flash, and brings the antenna out through either a U.FL connector or 1.27 mm stamp holes. Supply is 2.1–3.6 V — 3.9 V permanently damages the module — over −40 to 85 °C in a 15 × 15 × 2.3 mm shielded package.