Product

TPF25E-01-U1

Bluetooth LE 5.0 serial module on the Dialog DA14531: 14.5 × 10 mm with a PCB antenna, AT command control, 2 Mbps air rate, −94 dBm sensitivity and 9.5 µA advertising sleep current.

TX power
−19.5 to +2.5 dBm
Sensitivity
−94 dBm
Package
SMD with 1.1 mm half-hole pads

Request datasheet & pricing →

Technical specifications

Product

TPF25E-01-U1 Product specifications
TypeBluetooth LE 5.0 module
Form factor14.5 × 10 mm SMD with PCB antenna

Radio

TPF25E-01-U1 Radio specifications
ProtocolBluetooth LE 5.0
ChipsetDialog DA14531
Frequency range2402–2480 MHz, 2440 MHz centre
Air rate2 Mbps
Transmit power−19.5 to +2.5 dBm, 0 dBm typical
Receiver sensitivity−94 dBm
AntennaOn-board PCB antenna

Bluetooth

TPF25E-01-U1 Bluetooth specifications
RolesMaster, slave and observer
ConnectionsUp to 3 bound peers; 2 slaves in multi-link mode
Payload sizeAT+MTU 23–247 bytes, 244 bytes supported

Power

TPF25E-01-U1 Power specifications
Transmit current4.0 mA
Sleep current, advertising9.5 µA at a 1 s interval
Sleep current, connected62 µA at a 1 s interval
Wake current, advertising405 µA
Deep sleep2 µA at a 500 ms connection interval

Interfaces

TPF25E-01-U1 Interfaces specifications
SerialUART, AT command set
Control pinsWKP wake pin, RST, SWD
ConfigurationOver the air as well as over serial

Mechanical

TPF25E-01-U1 Mechanical specifications
Dimensions14.5 × 10 × 2.4 mm including shield
PackageSMD with 1.1 mm half-hole pads

Environment

TPF25E-01-U1 Environment specifications
Supply voltage2.3–3.6 V, 3.3 V typical
Operating temperature−40 to 85 °C

Overview

TPF25E-01-U1 is a Bluetooth LE 5.0 module built on the Dialog DA14531 with vendor AT firmware, so a product can gain BLE without integrating a protocol stack. It works as master, slave or observer, and carries its own PCB antenna on a 14.5 × 10 × 2.4 mm shielded package — small enough for a remote control or a battery sensor node.

Two modes cover most integrations: in transparent mode bytes written to the UART appear unchanged at the peer, and in configuration mode AT commands set the device name, 16- or 128-bit UUIDs, output power, baud rate and advertising interval, over the air as well as over the wire. Long packets are supported and the MTU is settable between 23 and 247 bytes.

Power is the reason to pick this part: 4 mA in transmit, 9.5 µA sleeping while advertising at a 1 s interval, 2 µA with advertising off, from a 2.3–3.6 V rail. It keeps up to three bound peers, or two slaves in multi-link mode, and is specified from −40 to 85 °C.