Product

TP1209-MP36

40.5 × 25 × 3.8 mm LCC module with 36 dBm output at 5.5 V, spread-spectrum FSK, -140 dBm at SF9.

Frequency
470–510 MHz
TX power
36 dBm
Sensitivity
-140 dBm
Package
LCC SMT

Request datasheet & pricing →

Technical specifications

Radio

TP1209-MP36 Radio specifications
Operating frequency470–510 MHz (configurable)
Transmit power36 [email protected] V
Receiver sensitivity-140 dBm(12kcps, SF9)-130 dBm(48kcps, SF7)
ModulationS-FSK
Channel bandwidth<200 kHz single carrier (configurable)
Downlink chip rate12Kcps/24Kcps/48Kcps/100Kcps
Uplink chip rate12Kcps/24Kcps/48Kcps/100Kcps
Antenna interfaceLCC pad/IPEX

Hardware

TP1209-MP36 Hardware specifications
Supply voltage5.5 V – 6.0 V typical 5.5 V
Interfaces1. AT UART: TTL level, 9600 bps; 2. debug UART: TTL level, 115200 bps; 3. RI signal; 4. wake-up input; 5. network-status LED; 6. SWD debug/programming
Current consumption (typical)TX current 1950 [email protected] V 36 dBm, ; RX current 55 [email protected] V
Operating temperature-40 °C to +70 °C
Storage temperature-40 °C to +90 °C
Dimensions40.5 × 25 × 3.8 mm
Pin count18
PackageLCC SMT

Overview

The TP1209-MP36 is the high-power member of the spread-spectrum family: 36 dBm transmit output at 5.5 V, with -140 dBm sensitivity at 12 kcps (SF9) and -130 dBm at 48 kcps (SF7).

It runs from 5.5–6.0 V and is packaged as an 18-pin LCC SMT module of 40.5 × 25 × 3.8 mm. Chip rates of 12, 24, 48 and 100 kcps are selectable; control is an AT UART at 9600 bps with a 115200 bps debug UART, plus RI, wake-up, RST_OUT, LED and SWD.

With 36 dBm at the connector pair and -140 dBm at the lowest rate, this module is chosen for gateways and concentrators rather than end nodes, where the downlink has to reach nodes at the edge of the cell.