
Product
TP1107-MP36
18-pin LCC 470–510 MHz module with -120 dBm sensitivity at 19.2 kbps and 5.5 V typical supply.
- Frequency
- 470–510 MHz
- TX power
- 17 dBm
- Sensitivity
- -120 dBm
- Package
- LCC SMT
Technical specifications
Radio
| Operating frequency | 470–510 MHz (configurable) |
|---|---|
| Transmit power | 17 dBm, configurable |
| Receiver sensitivity | -120 dBm |
| Modulation | FSK |
| Channel bandwidth | <200 kHz single carrier (configurable) |
| Downlink symbol rate | 19.2 kbps/76.8 kbps |
| Uplink symbol rate | 19.2 kbps/76.8 kbps |
| Antenna interface | LCC pad/IPEX |
Hardware
| Supply voltage | 5.0 V–6.0 V typical 5.5 V |
|---|---|
| Interfaces | 1. AT UART: TTL level, 115200 bps 2. debug UART: TTL level, 115200 bps 3. RI signal 4. wake-up input 5. network-status LED 6. SWD debug/programming 7. ANT( or IPEX)port |
| Current consumption (typical) | TX current 1900 [email protected] V; RX current 55 [email protected] V |
| Operating temperature | -40 °C to +70 °C |
| Storage temperature | -40 °C to +90 °C |
| Dimensions | 40.5 × 25 × 4.4 mm |
| Pin count | 18 |
| Package | LCC SMT |
Overview
The TP1107-MP36 is the most sensitive member of the TP1107 family, reaching -120 dBm at 19.2 kbps. Transmit power is 17 dBm, configurable, and the radio covers 470–510 MHz.
It is an 18-pin LCC SMT module measuring 40.5 × 25 × 4.4 mm and runs from 5.0–6.0 V (5.5 V typical). Control is over an AT UART at 9600 bps with a 115200 bps debug UART; RI, wake-up, RST_OUT, LED and SWD are exposed.
The extra 3 dB of sensitivity against the standard part translates into roughly double the usable range on the same antenna, so MP36 is the module to pick when the link is the hard constraint rather than cost or board space.
